14” to 8” Reverse Feeding Egan Extruder

Totally Rebuilt In 2004 Not Used Since
Rebuilt 14” to 8” 36:1 Single Stage Screw with Compression Ratio of 5:1
- Hard Facing is on Top of the Flight with #6 Satellite 48-52 RC
- Two Cooling Zones
- Spiral Maddox Mixer is on End of Screw
14” to 8” 36:1 Honed Barrel
- 0080 to .100 Hard Facing Remaining per Side. Hardness 62064 RC
Heating and Cooling System
1560 HP Double Reduction Gear Box
- Ratio 17:1
- Closed Loop Oil System
Rebuilt 600 hp Reliance DC Motor with 2HP Fan
Panel Box
- 600 HP DC Drive “Electric Regulator” (Extruder)
- 40HP AC Inverter “RM5” (Crammer Feeder)
- 15 Solid State Contactors
- 20HP DC Drive “Electric Regulator” (Pelletizer)
- Two 1000 Amp Breakers
- “Allen Bradley” PLC 32 (PLC to Synchronize the Whole System)
- Amp Meters (For Drives and Inverter)
- Digital Temperature Readouts for Each Zone
- Digital Pressure Gauge
- Eight Starters
Crammer Feeder
- Double Flighted Spiral and is Run by a 40HP Motor.
- Can Achieve a 300lbs./sq.in. Pressure with a One lb.cu.ft. Input
- Will Dramatically Increase the Output and the Consistency of the Extruder
Transefer Tube
- Four Heating Zones with Ceramic Heaters and “J” Type Thermocouples
Screen Changer
Pelletizer
Spin Dryer
Shaker Table